Uponor Smatrix Move Guía Rápida página 11

N O T E !
Some system parameter settings are only
accessible during the first 4 hours after
power up. This is done to prevent mistakes
after installation. If the locked system
parameter symbol is displayed, the power
to the controller has to be disconnected
and reconnected again to modify these
parameters. No settings are lost when
disconnecting or after a power failure.
The settings available while in run mode is
always accessible for change, and will not be
locked.
To enter system parameter settings:
1. Press and hold the OK button for about 10 seconds.
2. The settings icon is displayed in the top left hand
corner of the display, and the text Hot type, Cld
type, or rEv type (depending of current operating
mode) is displayed.
3. Use buttons < or > to locate a parameter (see list
below) and press OK.
Some of these parameters require other parameters
to activate them.
Menu Display Description
0 type Type of installation (heating and/
or cooling)
1 Cur Heating curve
See page 12 for more information
and a diagram
2 Hi Maximum supply temperature
(heating mode)
3 Lo Minimum supply temperature
(heating mode)
Cur
1 Cooling curve
See page 12 for more information
and a diagram
2 Hi Maximum supply temperature
(cooling mode)
3 Lo Minimum supply temperature
(cooling mode)
4 InSt Type of system (hydraulic
installation)
5* th Thermostat selection (installed/
wireless/etc, see the registration
instruction on pages 8 – 10)
U P O N O R S M AT R I X M O V E · Q U I C K G U I D E
Q U I C K G U I D E
*) Requires antenna A-155
**) Requires a return sensor
4. Use buttons - or + to change parameter settings.
5. Use buttons < or > to locate parameter 24 (End)
– Exit system parameter settings.
6. Press the OK button to exit the system parameter
settings.
Menu Display Description
6 tHty Not used by Move
7** BGAP Boost function if the difference
between the supply and return
temperature is too much
8* trF1 Wireless thermostat 1 configuration
(see the registration instruction on
pages 8 – 10)
9* trF2 Wireless thermostat 2 configuration
(see the registration instruction on
pages 8 – 10)
This thermostat controls the
operation of circulation pump 2
10* tr1o Supply temperature compensation
when using a thermostat to speed
up the system. Use with caution
11 in1 Wired input 1, select function
in2
12 Wired input 2, select function
OUSE
13 Outdoor sensor selection
(installed/wireless*/wired/etc,
see the registration instruction on
pages 8 – 10)
14 OUt Outdoor temperature, fixed value if
outdoor sensor is not installed
15* ourF Wireless outdoor sensor
configuration (see the registration
instruction on pages 8 – 10)
16 ˚C Display unit
17 00:00 Time unit (AM/PM/24H)
18 GriP Valve and pump exercise
19 PUMP Pump start delay after the mixer
valve is closed
20 ctrl Forced control of the actuator
21 PrH Floor/screed preheating program
DIN 1264-4
22 dry Floor/screed drying program
23 ALL Factory reset
Press and hold the OK button for
about 5 seconds
24 End Exit system parameter settings
UK
CZ
DE
DK
EE
ES
FI
FR
HR
HU
IT
LT
LV
NL
NO
PL
PT
RO
RU
SE
SK
1 1