Ribimex Ribiland PR4EN1T Manual De Instrucciones página 68

3. Remove the spark plug and pour about 3cm
Slowly pull the recoil starter 2 or 3 times so oil evenly coat the interior of the engine. Reinstall the
spark plug.
4. Before storing the machine, repair or replace any worn or damaged parts. Make sure the scabbard
is in place.
5. Remove the air cleaner element from the carburetor and clean it thoroughly with soap and water.
Rinse and dry thoroughly, then add a few drops of oil and work it in. Reassemble.
6. Store the machine in a clean, dust-free area.
CAUTION! Do not remove the D-shaped shim washer
from the gearcase clamp! The shim washer
prevents damage from over-tightening the
tube damp screw.
a. Loosen the gear case clamp bolt.
b. Remove the index bolt from the gearcase.
c. Side the gearcase out of the tube. Using a grease gun,
pump lithium-base grease (about 10 grams) into the
grease fitting on the gearcase until you see old grease
being purged from the gearcase (Fig.HT16). Purged
grease will be visible in the outer tube cavity. Clean up the
excess grease and then reassemble the gear case onto the
outer tube.
Make sure the index bolt fits into the hole on the outer
tube. Securely tighten both bolts.
7.3- Disposal
When disposing of your machine, remove oil and fuel from the machine, and be sure to follow the
local regulations. Do not dispose of in/with household rubbish
All manuals and user guides at all-guides.com
3
of oil into the cylinder through the spark plug hole.
Fig.HT16
1. Gear case Grease fitting