Bahco TAWM Serie Traducción De Las Instrucciones Originales página 10

TAWM SERIES
SLIM
Note: For a fixed length head, head length entered is offset length measured from center of
drive to center of fastener.
Offset
Note: For an interchangeable head, head length is measured from locking pin to center of drive.
SET HEAD LENGTH is set during calibration. If a different length head is used, enter new head
length and offset is calculated automatically.
Note: For an interchangeable head with an adapter, head length entered is sum of head length
and offset length.
USE OF NEGATIVE OFFSETS
Note: Enter a negative value for offset when used in reverse direction with flex head or when
calculating sum of interchangeable head and offset lengths.
Offset