Calibration Menu - Uline SCOUT H-9560 Manual Del Usuario

CALIBRATION MENU

ENTER THIS MENU TO PERFORM CALIBRATIONS.
Internal Calibration
Calibration Adjustment
Span:
Linearity:
End Calibration:
SPAN [SPAN]
Initiates a span calibration procedure (zero and span).
LIN [LIN]
Initiates a linearity calibration procedure (zero,
mid-point and span).
END CAL [End]
Advance to the next menu or return to the top of the
current menu.
SETUP MENU
ENTER THIS MENU TO SET SCALE PARAMETERS.
Reset
Auxiliary Graduation
Filter
Auto Zero Tracking
Stable
Backlight
Auto Tare
Auto Off
End Setup
NOTE: Bold always represents factory default.
RESET [rESEt]
Reset the setup menu to factory defaults.
• NO = Not reset
• YES = Reset
AUXILIARY GRADUATION [Au.GrAd]
Set whether the weight is displayed with the auxiliary
graduation when the security switch is in the locked
position.
• ON = The auxiliary graduation is displayed within
brackets.
• OFF = The auxiliary graduation is not displayed.
PAGE 10 OF 53
MENU SETTINGS CONTINUED
Perform
-100...0...100
Perform
Perform
Exit Menu
No, Yes
On, Off
Low, Med, High
Off, 0.5d, 1d, 3d
0.5d, 1d, 2d, 5d
Off, On, Auto
Off, On, On-Acc
Off, 1, 5, 10
Exit Menu
NOTE: If the scale will be used in direct sales to
the public, the OFF setting must be selected.
FILTER
Set the amount of signal filtering.
• LOW = Less stability, faster stabilization time
• MED = Normal stability, stabilization time
• HI = Greater stability, slower stabilization time
AUTO ZERO TRACKING
Set the automatic zero tracking functionality.
• Off = Disabled
• 0.5d = The display will maintain zero until a change
of 0.5 divisions per second has been exceeded.
• 1d = The display will maintain zero until a change of
one division per second has been exceeded.
• 3d = The display will maintain zero until a change of
three divisions per second has been exceeded.
STABLE RANGE
Set the amount the reading can vary while the stability
symbol remains on.
• 0.5d = 0.5 scale division
• 1d = 1 scale division
• 2d = 2 scale division
• 5d = 5 scale division
BACKLIGHT
Sets backlight functionality.
• Off = Always off
• On = Always on
• Auto = Turns on when a button is pressed or the
displayed weight changes.
NOTE: When powered by AC adapter, the
backlight is always on.
AUTO TARE
Sets the automatic tare functionality.
• Off = Automatic tare is disabled.
• On = The first stable gross weight is tared.
• On-acc = Stable gross loads within the accept limits
are tared (in Check Weighing mode).
1021 IH-9560