Thermador PROFESSIONALTMPRO HARMONY Manual De Instrucciones página 22

Installing a Backsplash with a Keep Hot
Shelf
A hood can be installed first if the Backsplash is to be
installed with a Keep Hot Shelf given that the Keep Hot
Shelf covers the top mounting screws of the Backsplash.
To protect against scratches, leave protective film on the
Backsplash until after installation is complete.
If range is already installed, refer to the manufacturer's
instructions to disconnect gas and power supplies. Move
range forward to gain access to rear of unit.
Figure 15: Backsplash with a Keep Hot Shelf
All manuals and user guides at all-guides.com
1. Locate wall studs. Wall studs are usually installed with
2. The height of the hood will determine the height of the
3. At the locations indicated in Figure 16, mount the lower
4. Remove Backsplash protective covering.
5. Start with the Keep Hot Shelf Installation.
a 16" (406 mm) or 24" (610 mm) space on center.
top edge of the Backsplash. The Backsplash should be
mounted so that the bottom rear edge of the Keep Hot
Shelf overlaps the Backsplash 1½" (38 mm).
shelf brackets included with the Keep Hot Shelf
through the Backsplash and into the wall studs.
• Due to variable wall stud widths and varying
Backsplash widths, in some cases, only one wall
stud may be found at the mounting location.
Figure 16: Backsplash with a Keep Hot Shelf
English 19