Figure 9
Figure 10
When in use, the snake should easily ma-
neuver itself into position going forward.
TIP! The cable can be bent into a certain
shape. This may help you maneuver the
cable into tight areas.
NOTE! The SeeSnake micro Inspection Cam-
era was not designed to take the place
of a drain cleaner or electrical/plumbing
fish sticks or tapes. In limited instances,
the SeeSnake micro Inspection Cam-
era's accessories can be used to re-
trieve small items like dropped rings
or screws.
Transportation &
Storage
1. Avoid exposing the unit to continuous vi-
bration or extreme hot and cold temper-
atures.
2. Always store the SeeSnake micro Inspec-
tion Camera indoors in the case it came
with.
All manuals and user guides at all-guides.com
SeeSnake
3. Always remove the batteries if the unit will
Maintenance
Instructions
CAUTION
been removed from the unit before performing
maintenance.
The SeeSnake micro Inspection Camera has
been designed to require little maintenance.
However, in order to maintain its perform-
ance, you must always follow these guide-
lines:
1. Always handle the device with care. It is
2. Always clean the imager head after use
3. Use only alcohol swabs to clean the con-
4. Avoid rubbing too hard on the LCD. After
5. Do not disassemble this device beyond
Service and Repair
Tool should be taken to a RIDGID Independent
Authorized Service Center or returned to the
factory. All repairs made by Ridge service facil-
ities are warranted against defects in material
and workmanship.
If you have any questions regarding the ser-
vice or repair of this machine, call or write to:
For name and address of your nearest Inde-
pendent Authorized Service Center, con-
tact the Ridge Tool Company at (800)
519-3456 or http://www.ridgid.com or
www.seesnake.com
Ridge Tool Company
®
micro
™
Inspection Camera
not be used for an extended period of
time.
Make sure the batteries have
not shock-resistant and should not be
banged or dropped. Treat it as you would
any other sensitive optical device.
with soap and mild detergent.
nections.
use, wipe the display clean gently with a
dry cloth.
what is shown in the manual. Doing so
will void your warranty.
CAUTION
Ridge Tool Company
Technical Service Department
400 Clark Street
Elyria, Ohio 44035-6001
Tel: (800) 519-3456
E-mail: [email protected]
7
Capítulos
