Pipe Tape
Your new faucet is designed for years of trouble-free performance. Keep it
looking new by cleaning it periodically with mild soap, rinsing thoroughly with
warm water and drying with a clean, soft cloth. Do not use abrasive cleaners,
steel wool or harsh chemicals, as these will dull the finish. Failure to follow
these instructions may void your warranty.
For safe operation of the faucet, please observe the following:
Operating Pressure:
Minimum Pressure .................20 psi (0.14 MPa), dynamic
Maximum Pressure ................80 psi (0.55 MPa), static
Do not use the product at an ambient temperature below
Spout Installation
1. Insert spout through the
center hole.
2. Insert the lift rod from beneath
the faucet and thread it into
the lift knob.
3. Slide the bracket into place
and secure the spout
with nuts.
4. Adjust the spout to face
forward. Hold the spout in
place and tighten nuts.
5. Install the T-Connector onto
the spout shank. Do not over
tighten.
COMMON TOOLS NEEDED
Adjustable Wrench
CARE & CLEANING
WARNINGS
INSTALLATION PROCEDURE
Adjustable Pliers
Spout
T-connector
3
Phillips Screwdriver
32 ºF (0 ºC).
Lift knob
Bracket
Nut
Lift rod