Building - Dremel 3D40 Traducción De Las Instrucciones Originales

1. Ensure 3D40 power switch is in the off position.
2. Connect the included USB cable to your 3D40 and
3. Open software.
4. Turn your Dremel 3D40 on using the power switch
knob by 1. Ensure 3D40 power switch is in the off position.
e 2. Plug ethernet cable into your 3D40, figure 6.
erify that 3. Turn your Dremel 3D40 on using the power
er
indicate
ruder will
ess can
when you
cally
lete the
All manuals and user guides at all-guides.com
CONNECTING USB CABLE
computer, figure 5.
to sync your computer to your Dremel 3D40.
CONNECTING ETHERNET
switch. Ethernet connection should be detected
automatically. Tap "Accept" to confirm connection.
USB
FIG. 5
Ethernet
FIG. 6

BUILDING

OBSERVE ALL PROVIDED
WARNING
!
WARNINGS AND SAFETY
INSTRUCTIONS WHEN USING THE DREMEL 3D40.
Failure to do so may result in fire, equipment
damage, property damage or personal injury.
DO NOT REACH INSIDE THE
WARNING
!
DREMEL 3D40 WHILE IT IS IN
OPERATION. Contact with Dremel 3D40 moving parts
during operation may result in poor build quality,
equipment damage or personal injury.
NOTE: Your Dremel 3D40 will build test objects before
leaving the factory. These test objects may have been
made with a different filament color than you are
using. Therefore, a small amount of filament may be
remaining in the extruder. The start of your first object
may have some of this filament color until it transitions
over to your filament color.
You have several options when building on your 3D40:
1) On-Printer Storage
2) USB Flash Drive
3) Computer
375