Building - Dremel 3D40 FLEX Instrucciones De Funcionamiento Y Seguridad

Ocultar thumbs Ver también para 3D40 FLEX:
Tabla de contenido
Idiomas disponibles

Idiomas disponibles

DM 2610039151 10-18.qxp_3D40 10/8/18 10:34 AM Page 28
CONNECTING USB CABLE
1. Ensure 3D40 power switch is in the off
position.
2. Connect the included USB cable to your
3D40 and computer, figure 10.
3. Open software.
4. Turn your Dremel 3D40 on using the
power switch to sync your computer to
your Dremel 3D40.
CONNECTING ETHERNET
1. Ensure 3D40 power switch is in the off
position.
2. Plug ethernet cable into your 3D40,
figure 11.
3. Turn your Dremel 3D40 on using the
power switch. Ethernet connection should
be detected automatically. Tap "Accept" to
confirm connection.
instructions when using the Dremel 3D40.
Failure to do so may result in fire, equipment
damage, property damage or personal injury.
in operation. Contact with Dremel 3D40
moving parts during operation may result in
poor build quality, equipment damage or
personal injury.
Getting Ready to Build

Building

Observe all provided
warnings and safety
Do not reach inside the
Dremel 3D40 while it is
FIG. 10
FIG. 11
NOTE: Your Dremel 3D40 will build test
objects before leaving the factory. These test
objects may have been made with a different
filament color than you are using. Therefore,
a small amount of filament may be remaining
in the extruder. The start of your first object
may have some of this filament color until it
transitions over to your filament color.
You have several options when building on
your 3D40:
1) On-Printer Storage
2) USB Flash Drive
3) Online Print Queue
4) Computer
28
USB
Ethernet
Tabla de contenido
loading

Tabla de contenido