Intended Use - BGS technic 1271 Manual De Instrucciones

COMPONENTS
1 Pressure gauge with hose 0-255 kg/cm² (0-25 Mpa)
2 Swivel fitting 45 degree
3 Adapter
FITTINGS
7/16-24 Straight fitting (x2)
1/4-28 Straight fitting (x2)
3/8-24 Straight fitting (x2)
5/16-24 Straight fitting (x2)
7/16-20 Straight fitting (x2)
ATTENTION
Read the operating instructions and all safety instructions contained therein carefully before using the
product. Use the product correctly, with care and only according to the intended purpose. Non-
compliance of the safety instructions may lead to damage, personal injury and to termination of the
warranty. Keep these instructions in a safe and dry location for future reference. Enclose the
operating instructions when handing over the product to third parties.

INTENDED USE

This product is used to test the hydraulic brake pressure directly on the wheel brake cylinder, brake
caliper, master cylinder or the hydraulic pump unit on Teves ABS with pressure accumulator and
allows to measured pressure differences in the two brake circuits.
BGS technic KG
Bandwirkerstr. 3
D-42929 Wermelskirchen
Brake Pressure Test Gauge Set
Tel.: 02196 720480
Fax.: 02196 7204820
[email protected]
4 Swivel fitting 90 degree
5 Teves adapter
6 Fittings
M7x1.0 Straight fitting (x2)
M8x1.25 Straight fitting (x2)
M10x1.5 Straight fitting (x2)
M10x1.0 Bleeder adapter (x2)
www.bgstechnic.com
© BGS technic KG, Copying and further use not allowed
BGS 1271