Removing And Storing Latch Connectors - Cybex Platinum ATON Q Manual Del Propietário

REMOVING AND STORING LATCH CONNECTORS

TO REMOVE FROM STORAGE
To install the Base using LATCH, the Connectors must be
removed from their storage compartments.
1. To access the LATCH Connector Storage compartments, squeeze
the Level Adjustment Handle to fully extend the Leveling Foot.
2. Remove each connector by pushing the
red button while pulling out.
3. Lengthen the strap between the connectors using the LATCH
Strap Adjuster located next to the connector on the right-hand
side. Push down on the Adjuster button while lengthening strap.
TO STORE
When using a vehicle belt to secure the Base, the LATCH
Connectors MUST be stored in the Base. Loose Connectors
could seriously injure vehicle occupants in the event of a crash.
1. Fully extend the Leveling Foot and slide each connector
back into its Storage slot until an audible CLICK is heard.
2. Close and Lock the Belt Tensioning Plate.
3. Remove any slack from the LATCH strap by pulling
on the LATCH Strap Tensioning Loop.
Do not remove more slack from the LATCH Strap than necessary to
allow it to lie flat on the bottom of the Base between the Belt Guides.
4. Retract the Leveling Foot by squeezing the Level
Adjustment Handle and pushing in the Leveling Foot.
DO NOT OVERTIGHTEN the Latch Strap, as this will
interfere with the Belt Tensioning Plate when installing
the Base using vehicle belts.
1
1
CLICK!
3
2
3
2
LATCH STRAP
26