Removing And Storing Latch Connectors - Cybex Platinum CLOUD Q Manual Del Propietário

TO REMOVE FROM STORAGE
To install the Base using LATCH, the Connectors must be
removed from their storage compartments.
1. To access the LATCH Connector Storage compartments, squeeze
the Level Adjustment Handle to fully extend the Leveling Foot.
2. Remove each connector by pushing the
red button while pulling out.
3. Lengthen the strap between the connectors using the LATCH
Strap Adjuster located next to the connector on the right-hand
side. Push down on the Adjuster button while lengthening strap.
TO STORE
When using a vehicle belt to secure the Base, the LATCH
Connectors MUST be stored in the Base. Loose Connectors
could seriously injure vehicle occupants in the event of a crash.
1. Fully extend the Leveling Foot and fully extend
the latch strap. Slide each connector back into its
Storage slot until an audible CLICK is heard.
2. Close and Lock the Belt Tensioning Plate.
3. Remove most of the slack from the LATCH strap
by pulling on the LATCH Strap Tensioning Loop
until it lays flat on the bottom of the base.
Do not remove more slack from the LATCH Strap than necessary to
allow it to lie flat on the bottom of the Base between the Belt Guides.
4. Retract the Leveling Foot by squeezing the Level
Adjustment Handle and pushing in the Leveling Foot.
DO NOT OVERTIGHTEN the Latch Strap when storing,
as this will interfere with the Belt Tensioning Plate
when installing the Base using vehicle belts.
27

REMOVING AND STORING LATCH CONNECTORS

1
1
CLICK!
3
2
3
2
LATCH STRAP