Configuring A Panel For The Steering Position Where The Panel Is Placed - Vetus ELPS Manual De Instalación

4 .7 Configuring a panel for the steering position
where the panel is placed
Carry out the following actions on EACH panel in the order indi-
cated:
N.B. The panel must be in the OFF position (if the panel is NOT in the
OFF position, first long press the "START/STOP" button to turn the
panel to the OFF position.
1
2
10 seconds
2 Place the panel in configuration mode.
• Press and hold the 'START/STOP' button for 10 seconds.
3
didahdi ( . − . )
4
OR
Helm station
1 2 3 4
4 Select the steering position where the panel is located by moving the lever momentarily from neutral to
the left or right and back again. The color and the flashing of the LED indicate the number of the helm
position.
For a port and starboard panel, together on a helm station, the
set helm station number must be the same .
vetus® Installation manual E-Drive motor control lever ELPS - ELPSR
1 Move the lever to the right.
dididididididid ( . . . . . . )
6 seconds
3 Press the 'START/STOP' but-
ton to confirm. Now the
panel is in configuration
mode.
Helm station
1 2 3 4
n
ote
3
dididididah ( . . . . − )
Con guration mode
4 seconds
During the first 6 seconds, the buzzer will continuously signal a did-
ididididi ..... (. . . .). Keep pressing the START/STOP button. After 10
seconds the buzzer sounds the signal dididididah (. . . - -).
1 BLUE, ashing
2 RED, ashing
3 BLUE, ashing
RED, quick ashing
4 BLUE and RED,
simultaneously ashing
Settings are retained when the power supply is switched off!
ENGLISH
2
1
5
1 x
5 Press the 'START/STOP' but-
ton once to confirm the set-
ting.
n
ote
0370401.11
13