Using Tracks To Record And Mix Parts - Casio CDP-200R Guia Del Usuario

CDP200R_03_e.fm 47 ページ ２００８年５月１日 木曜日 午前１０時１７分
8.
8
Press twice to exit the recorder mode.
Disappears
• The flashing on the screen shown in step 3 becomes
faster when remaining recorder memory capacity
becomes less than 100 notes.
• Total recorder memory capacity is approximately
12,000 notes. Recording will stop automatically when
there is no more unused recorder memory remaining.
8
• Each press of cycles through the settings shown
below. You can listen to the recorded data as many
times as you like by pressing
standby.
Playback
Recorder Off
Standby
Disappears Lights
■ To delete recorded data
In step 3 of the above procedure, do hold down
pressing any keyboard key) until the message "Tr.Del?"
appears on the display. Press [+] (YES) to delete the data, or
[–] (NO) to cancel the delete operation.
• Turning off the piano while recording is in progress will
cause any data in recorder memory to be deleted.
• A new recording replaces (deletes) previously recorded
contents.
■ Maintaining Data in Recorder Memory
After you save data in recorder memory, it will remain there as
long as power is supplied to the piano. However, if you
disconnect the AC adaptor, data in recorder memory will be
deleted.
All manuals and user guides at all-guides.com
bo
while in playback
Record
Standby
Flashes
8
(without
Recording Your Keyboard Play
Using Tracks to Record and Mix
Parts
You can divide a song according to various types of parts
(instrument, left and right hand, etc.), and record each part to
a specific track. You can mix up to six tracks (the original track
plus five additional tracks) into a final song.
■ About tracks
Tracks are numbered from 1 to 6.
• If you do not specify a track number when recording,
recording is performed to Track 1 automatically.
In addition to what you play on the keyboard, the following
information also is recorded.
• Track 1
Settings:
Tone number, rhythm number, tempo, reverb, chorus,
chords, layer/split settings, Auto Harmonize/Arpeggiator
setting
Operations:
Pedal, pitch bend wheel, INTRO button, SYNCHRO/
ENDING button, NORMAL/FILL-IN button, VARIATION/
FILL-IN button
• Tracks 2 through 6
Tone number, pedal operation, pitch bend wheel operation
To record to Tracks 1 through 6
1.
Record the first part to Track 1.
To record to Track 1, perform steps 1 through 4 under
"Recording and Playing Back Keyboard Play" (page
E-46).
Lights
Lights
2.
8
Press .
This will enter record standby.
Flashes
Flashes
E-47