Incorporating A Sampled Sound Into A Drum Set (Drum Sampling) - Casio CDP-200R Guia Del Usuario

CDP200R_e.book 19 ページ ２００８年４月２１日 月曜日 午後３時４分
Applying Effects to a Sampled Sound
You can apply various effects to sampled sounds.
1. bt
Press and then use
tone number (671 to 675) to which you want to
apply effects.
2.
bt
Press to cycle thorough the available
effects, described below.
Effect Type
(Display)
Normal sampled tone (no looping, no
Original (Orgnl)
effect).
Loop 1 (Loop1) Loops the sampled sound.
Loops the sample sound and raises the
Loop 2 (Loop2) pitch of the resonating sound when the
keyboard key is released.
Loops the sample sound and lowers the
Loop 3 (Loop3) pitch of the resonating sound when the
keyboard key is released.
Changes the pitch from low to high, at an
Pitch 1 (Ptch1)
increasing rate.
Changes the pitch from high to low, at a
Pitch 2 (Ptch2)
decreasing rate.
Changes the pitch from high to low, at a
Pitch 3 (Ptch3) decreasing rate, and then raises the pitch
when the key is released.
Tremolo (Treml) Alternates volume between high and low.
Adds vibrato and changes the pitch by a
Funny 1 (Funy1)
gradually increasing amount.
Alternates between high pitch and low
Funny 2 (Funy2)
pitch.
Adds vibrato and changes the pitch from
Funny 3 (Funy3)
low to high.
• Avoid assigning the same sampled sound (tone number
671 to 675) to the keyboard for play along and for looped
play. Doing so will cause, the Loop 1 effect to be applied to
the keyboard tone while looped play of the sampled sound
is being performed.
All manuals and user guides at all-guides.com
Sampling Sounds and Playing Them on the Digital Piano
cl
(10-key) to enter the
Description
Incorporating a Sampled Sound
into a Drum Set (Drum Sampling)
You can use the procedure to change the drum sounds that
are assigned to each keyboard key.
• You can store up to three drum sets and store them as tone
numbers 676, 677, and 678. Simply select the tone number
where the drum set you want is located to assign the drum
set sounds to the keyboard.
1.
bs
Press .
bs
lights.
2.
bt cl
Press and then use
tone number (676, 677, or 678) for the drum set
whose sounds you want to change.
N o D a t a
• In place of the above steps, you could press
at the same times and then select a tone number.
3.
6
Press .
N o D a t a
(10-key) to enter the
Lights 6 bs
and
Flashes
E-19