Switching The Clipper On And Off; Using The Clipper; Replacing The Clipping Blades - Heiniger Xperience Traducción De Instrucciones Originales

Fig. 3
NOTE!
If the clipping pressure is too low, hair can gather between the
X
shearing blades. This results in a poor clipping quality. In this
case, clean the clipping blades as described in chapter 6.7.
6.3

Switching the clipper on and off

Fig. 4
6.4

Using the clipper

Approach the animal from the front.
X
Secure the animal to be sheared and calm it down.
X
Plug the power plug into the socket.
X
Switch the shearing machine on while you are in the visual range of the
X
animal.
Observe the animal's behaviour while clipping.
X
Switch the clipper off after you have finished clipping and pull the plug
X
from the socket.
6.5

Replacing the clipping blades

Fig. 5
12
Translation of the original instructions / Cattle clipper Xperience
X
0
X
I
X
X
X
X
X
If the clipping quality deteriorates,
increase the clipping pressure by
turning the adjusting knob another
1/4 turn in the direction of the arrow.
If this does not produce the desired
result, the shearing blades must be
replaced or sharpened.
To switch the clipper on, slide the
ON/OFF switch to the position I.
To switch the clipper off, slide the
ON/OFF switch to the position 0
(see Fig. 4).
Switch the clipper off by sliding the
switch to the position "0".
Pull the plug from the socket.
Turn the adjusting knob in the
direction of the arrow until the
resistance decreases.
Place the clipper with the comb plate
screws facing upwards on a flat
surface.