General Notes - Scheppach hmc 3200 ci Traducción De La Instrucción De Original

Documentation

GENERAL NOTES

After unpacking, check all components for possible damage occurring during transportation. Delivery personnel must
be informed immediately of any claims.
Claims made at a later date will not be recognised.
Check that the delivery is complete.
Before using, familiarise yourself with the machine with the help of the operating instructions.
For accessories, replacement and spare parts, use only original scheppach components.
Spare parts can be obtained from your scheppach dealer.
When ordering, state our item numbers as well as the model and year of the device.
In these operating instructions, we have highlighted notes relating to your safety with the following sign.
Pass on these safety notes to everyone who works at the machine.
Observe all safety and hazard notices on the machine.
Maintain all safety and hazard notices on the machine in a legible condition.
Caution when operating: Danger of injury to fingers and hands by the rotating cutting tool.
Maximum planing block rotational speed 6500 1/min.
The planing block was manufactured in accordance with the DIN EN 847-1.
Make sure that the machine is standing stable on firm ground.
Only begin the working cycle when the full rotational speed has been reached.
Check the lines to the power connection. Do not use faulty lines. See Electrical connection.
Make sure that the planing machine is standing stable on firm ground when mounting.
Keep children away from the machine when it is connected to the electricity supply.
The operator must be at least 18 years old. Trainees must be at least 16 years old, but may only work at the machine
under supervision.
Persons working at the machine must not be distracted.
The operating station of the machine must be kept free of shavings and waste wood.
Wear tight-fitting clothes. Remove jewelry, rings and wrist-watches.
Pay attention to the rotational direction of the motor and tool, see "Electrical connection planing machine".
The safety devices on the machine may not be removed or rendered unusable.
When working at the machine, all protective devices and covers must be installed.
Equipping, adjusting, measuring and cleaning work may only be carried out with the motor is switched off. Pull out the
plug and wait for the rotating tool to come to a standstill.
The complete protective and safety devices must be remounted following repair and maintenance work.
Installation, repairs and maintenance on the electric installation may only be carried out by qualified professionals.
When correcting faults, switch the machine off. Pull out the plug.
The grippers have to be smooth-running and free of particles.
An exhaust system should be used to remove wood shavings and sawdust. The flow rate at the suction nozzle must be at
least 20 m/s.
Only work with sharpened planing knives. Blunt planing knives increase the danger of kickback.
Defective planing knives (splits or similar) are to be replaced immediately. See Knife replacement.
The planing block guard should always be adjusted to the width of the workpiece. The part of the knife block not in use
must be covered.
When planing short workpieces, a feed loader must be used.
With inset work, always use the settings that prevent the tool backfiring.
Check the effectiveness of the kickback prevention device before every shift. The claw points must be square-edged.
When leaving the workplace, switch off the motor. Pull out the plug.
The complete protective and safety devices must be remounted following repair and maintenance work.
Even when only moving the machine a short distance, disengage it from every external energy supply! Before bringing the
machine into service again, reconnect it to the mains carefully
The workpiece has to be checked for possible defects, as foreign bodies, knots, depressions, chatter marks, torsions,
before start of work.
Page:24
9322 0311