Maintenance; Cleaning - Hoshizaki DCM-60KE Manual De Instrucciones

Dispensador de cubitos de hielo
Tabla de contenido
Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 64
ENGLISH
1) Follow the instructions in "7. SHUT DOWN".
2) Remove the inlet hose from the water supply tap, and drain the hose.
3) Ask for draining of the ice dispenser by professional qualified personnel.
III. MAINTENANCE

1. CLEANING

Before carrying out any cleaning or maintenance operations, unplug the ice dispenser from the electrical supply network.
This appliance must not be cleaned by use of a water jet.
When using a neutral cleaner or sodium hypochlorite, thoroughly read and understand the instructions provided to prevent
potential health problems.
Ask a trained service person to clean and sanitize the ice dispenser water system at least twice a year and to check and clean
the condenser at least once a year.
To prevent possible damage, do not clean the plastic parts with water above 40°C or in a dishwasher.
[a] Exterior
Wipe the exterior at least once per week with a clean, soft cloth. Use a damp cloth containing a neutral cleaner to wipe off
grease or dirt.
[b] Front Panel, Spout, Push Lever, Ice Dispensing Outlet Cleaning/Sanitisation (Daily)
1) Remove the front cover by holding the notches on both sides and pulling it toward you. See "II. 3.
FRONT COVER".
2) Loosen the band to disconnect the water pipe (A).
3) Hold the hooks on both sides of the spout, and pull it
toward you.
4) Either mix 1 litre of water with 4 ml of 5.25% sodium
hypochlorite solution in a suitable container, or the
recommended Hoshizaki sanitiser as directed.
5) Soak a clean cloth with the solution, and wipe the front
cover.
6) Soak the spout in the solution for more than 3 minutes.
Use the accessory brush to clean the water pipe (B).
Rinse thoroughly, and shake to remove surplus liquid.
Note: Using a cloth to dry may re-contaminate.
7) Soak a clean cloth with the solution, and wipe the parts
around the ice dispensing outlet and the push lever.
8) Replace the spout by holding the hooks on both sides
and inserting them into the holes.
9) Use the band to reconnect the water pipe (A) to the
spout.
WARNING
CAUTION
NOTICE
Water Pipe (A)
Band
Front Cover
Water Pipe (B)
Spout
Hole (both
sides)
Spout
1
10
Spout
Brush
Push Lever
Water Pipe (A)
Band
Hook
(both sides)
Hook
(both sides)
Ice Dispensing
Outlet
2
Tabla de contenido
loading

Este manual también es adecuado para:

Dcm-60ke-pDcm-120keDcm-120ke-p

Tabla de contenido