Usb Playback - Sony XAV-712BT Manual De Instrucciones

USB playback

Items cannot be played via a USB hub.
 Connect iPod/USB devices to this unit without
USB hub.
Items cannot be played.
 Reconnect the USB device.
The USB device takes longer to play.
 The USB device contains large-sized files or files
with a complicated tree structure.
The sound is intermittent.
 The sound may be intermittent at a high bit rate
of more than 320 kbps.
 This is not a malfunction. This phenomenon
occurs during USB Video playback, when;
 the HOME button is pressed.
 the system setting is launched.
 USB photo/navigation function is ongoing.
BLUETOOTH function
The other BLUETOOTH device cannot detect this
unit.
 Set [Signal] to [ON] (page 23).
 While connecting to a BLUETOOTH device, this
unit cannot be detected by another device.
Terminate the current connection and search for
this unit from the other device. The disconnected
device can be reconnected by selecting from the
list of registered devices.
Connection is not possible.
 Check the pairing and connection procedures in
the manual of the other device, etc., and perform
the operation again.
The name of the detected device does not
appear.
 Depending on the status of the other device, it
may not be possible to obtain the name.
There is no ringtone.
 Raise the volume while receiving a call.
 Depending on the connecting device, the
ringtone may not be sent properly.
 Set [Ringtone] to [Internal] (page 19).
The talker's voice volume is low.
 Raise the volume during a call.
The other party says that the volume is too low
or high.
 Adjust the [MIC Gain] level (page 18).
Echo or noise occurs during call conversations.
 Reduce the volume.
 [Speech Quality] is set to [Mode 1].
 Set [Speech Quality] to [Mode 2] (page 18).
40
GB
 If ambient noise other than the phone call sound
is loud, try reducing this noise.
 Shut the window if road noise is loud.
 Lower the air conditioner if the air conditioner
is loud.
The phone sound quality is poor.
 Phone sound quality depends on reception
conditions of the cellular phone.
 Move your car to a place where you can
enhance the cellular phone's signal if the
reception is poor.
The volume of the connected BLUETOOTH device
is low or high.
 Volume level will differ depending on the
BLUETOOTH device.
 Reduce the volume level differences between
this unit and the BLUETOOTH device (page 14).
The sound skips during audio streaming.
 Reduce the distance between the unit and the
BLUETOOTH device.
 If the BLUETOOTH device is stored in a case which
interrupts the signal, remove the case while
using the device.
 Several BLUETOOTH devices or other devices
which emit radio waves are used nearby.
 Turn off the other devices.
 Increase the distance between the unit and
other devices.
 Playback sound stops momentarily when this
unit is connecting to a cellular phone. This is not
a malfunction.
You cannot control the connected BLUETOOTH
device during audio streaming.
 Check that the connected BLUETOOTH device
supports AVRCP.
Some functions do not work.
 Check that the connecting device supports the
functions in question.
The name of the other party does not appear
when a call is received.
 The other party is not stored in the phonebook.
 Add the other party to the phonebook
(page 18).
A call is answered unintentionally.
 The connecting phone is set to start a call
automatically.
 [Auto Answer] of this unit is set to [3 sec] or [10
sec] (page 19).
Pairing failed due to time out.
 Depending on the connecting device, the time
limit for pairing may be short. Try completing the
pairing within the time by setting a single digit
passkey.