Emerson ION ECO CF5300BS00 El Manual Del Propietario página 6

3. Ceiling Fan Assembly
3.4
Place the 6" Downrod into the Motor Coupler, aligning the
Clevis Pin Holes in the Downrod with the Holes in the
Motor Coupler (Figure 4).
The Clevis Pin must go through the Holes in the Motor
Coupler and the Holes in the Downrod.
Be sure to push the straight leg of the Hairpin Clip through
the Hole near the end of the Clevis Pin until the curved
portion of the Hairpin Clip snaps around the Clevis Pin.
The Hairpin Clip must be properly installed to prevent the
Clevis Pin from working loose.
Pull on the Downrod to make sure the Clevis Pin is
properly installed.
WARNING
!
It is critical that the clevis pin in the motor coupler is
properly installed. Failure to verify that the pin is properly
installed could result in the fan falling.
3.5
While pulling up on the 6" Downrod, retighten the two Set
Screws (previously loosened) in the Motor Coupler to
secure the Downrod into place (Figure 5).
NOTE: The Set Screws must be properly installed as
described above, or fan wobble could result.
WARNING
!
It is critical that the set screws are securely tightened.
Failure to verify that the set screws are properly installed
could result in the fan falling.
3.6
Make sure the Grommet is properly installed in the Motor
Coupler Cover, then slide the Motor Coupler Cover on the
Downrod until it rests on the motor housing (Figure 6).
(Continued)
HAIRPIN
CLIP
CLEVIS
PIN
MOTOR
COUPLER
CLEVIS
PIN
Figure 4
MOTOR
COUPLER
Figure 5
Figure 6
6
6" DOWNROD
HAIRPIN
CLIP
6" DOWNROD
RETIGHTEN SET
SCREWS (2)
6" DOWNROD
GROMMET
MOTOR
COUPLER
COVER