Optional Installation Of No-Light Cover - Emerson ION ECO CF5300BS00 El Manual Del Propietario

7. Optional Installation of No-Light Cover

WARNING
!
Turning off wall switch is not sufficient. To avoid possible
electrical shock, be sure electricity is turned off at the
main fuse box before wiring. All wiring must be in
accordance with National and Local codes and the ceiling
fan must be properly grounded as a precaution against
possible electrical shock.
IMPORTANT: Disconnection of the LED Light Fixture
Assembly Terminals from the Fan Motor Housing
Terminals prior to Assembly of the No-Light Cover is
necessary.
7.1
Remove and retain the Shade Assembly from the opening
of the LED Light Fixture Assembly by turning the Shade
Assembly counter-clockwise (Figure 26).
NOTE: Store the Shade Assembly in a safe place for
future use, if needed.
7.2
Remove one of the #8-32 x 10mm Flat Head Screw from
the LED Light Fixture Assembly (Figure 27).
Retain the #8-32 x 10mm Flat Head Screw for future
installation.
Loosen the two #8-32 x 10mm Flat Head Screws in the
key hole slots (Figure 27).
Rotate the LED Light Fixture Assembly counter-clockwise
to disengage the Fixture from the two loosened screws.
Carefully let the LED Light Fixture Assembly hang to
disengage the terminals.
LED LIGHT
FIXTURE
ASSEMBLY
DIMPLES
SHADE ASSEMBLY
ROTATE SHADE ASSEMBLY COUNTER-CLOCKWISE TO
DISENGAGE TO THE LED LIGHT FIXTURE ASSEMBLY DIMPLES
Figure 26
LED LIGHT FIXTURE LOOSEN TWO
ASSEMBLY #8-32 x 10mm FLAT
HEAD SCREWS
REMOVE ONE #8-32 x 10mm
FLAT HEAD SCREW
Figure 27
17