Wall Control Procedures - Emerson ION ECO CF5300BS00 El Manual Del Propietario

8.1
Your Emerson Ceiling Fan/Light Control consists of Wall
Mounted Transmitter and a Receiver located inside the
Motor Assembly. The Control is designed to remotely
operate your Ceiling Fan speed, light intensity and
direction of rotation.
8.2
Your Wall Control has Code Switches which must be set
in one of 32 possible
(Figure 31). The five Levers (numbered 1, 2, 3, 4, and 5)
on the Switches are factory-set in the ON (up) position.
Change the Switch settings as follows:
NOTE: Do not duplicate the code of an existing
Control of an installed Ceiling Fan within 100 feet.
8.3
Slide the five Switch Levers in the Wall Control to your
choice of ON (up) or down positions. Use a ball-point pen
or small screwdriver and slide the Levers firmly up or
down.
8.4
The sixth Switch marked ON and I is for dimming Control
of Lights: Set Switch to ON to allow for dimming of the
lights. Set Switch to I for no dimming of the Lights.
8.5
Preset Memory Feature: Your Emerson Ceiling Fan/Light
Control is equipped with a preset memory feature.
When the electricity supply to the Fan is switched OFF,
the Control will remember the light intensity and fan
speed.
When the Switch is turned back ON, the Light and Fan will
resume operation as they were prior to the Switch being
turned OFF.

8. Wall Control Procedures

code combinations
Code switches in the Transmitter may be set in
32 different positions. If your Fan and Light turn on and
off without using your Control, you may be getting
interference from other remote units such as garage
door openers, car alarms or security systems.
To remedy this situations, simply change the code
switches in your Transmitter per the instructions of
Sections 8.2 - 8.5.
Figure 31
20
WALL CONTROL
CODE SWITCHES
1 - 5
ON
1 2 3 4 5
I
DIMMING
SWITCH
I
CODE
SWITCHES
WALL
CONTROL