Scope Of Supply; Assembly Sequence - AL-KO CLASSIC 3.2E Manual Del Usuario

Assembly

Scope of supply

1x operating instructions
1x assembly instructions
1x upper bar
2x lower bar
1x grass catcher, upper part
1x grass catcher, lower part
1x baffl e
2x front wheel / wheel cap Ø 125 or 150
2x rear wheel / wheel cap Ø 150 or 180
1x bag of screws
1x cable holder
1x cable strain relief

Assembly sequence

See illustrations in the assembly instructions.
Assembly of baffl e (a - c)
Assembly of baffl e
1
1. Insert the bearing rod of the baffl e.
2. Pull left-hand / right-hand springs forward until
they engage.
3. Secure the baffl e holder with a Ø 4,2x15 screw.
Assembly of the bars
Assembly of lower bar in housing
2
1. Insert lower bar into the recesses as far as the
stop and secure on each side with a Ø 4,8x16
screw.
Assembly of upper bar on lower bar (a - c)
3
1. Push on cable strain relief.
2. Fasten upper bar to lower bar with screw and
wing nut.
470512_a
Assembly of bearing components on upper bar
4
(a - c)
1. Push on cable fi xing clamp.
2. Mount switch/connector combination with 2
screws Ø 4x25.
Assembly of wheels (a - c)
Assembly of wheels
5
1. Push wheel onto axle until it clicks into place.
2. Insert axle at desired cutting height.
3. Holding onto the fi rst wheel, push on the se-
cond wheel. This wheel must also click into
place.
Assembly of grass catcher
Assembly of grass catcher parts
6
1. Push the upper part onto the pins of the lower
part of the grass catcher.
Securing the grass catcher parts
7
1. Close both parts of the grass catcher together
and secure with 2 Ø 4,2x15 screws.
8
Attaching the grass catcher
1. Lift the baffl e.
2. Lift the grass catcher and attach it in place.
3. Press the baffl e.
Handling
Adjusting the cutting height (a - c)
9
1. With the button pressed, pull off the wheel.
2. Pull out the axle and reinsert at the desired
cutting height.
3. Push wheel back on until it clicks into place.
4. Adjust the second axle in the same way.
GB
11