Specific Maintenance; Mounting The Handlbar - Honda UM 516 C Manual Do Utilizador

Land-related risks :
- If the area is a steep incline : never trim going up or down the slope, but follow a line at right ongles to the slope.
- If the area is covered with natural or man-made obstacles, such as rocks, loose stones, tree trunks, bottles, pieces of metal,
stakes, and all types of foreign objects, these may become dangerous projectiles and put undue pressure on the cutting
tool. They should therefore be avoided.
- Beware of slipping on sloping or wet ground.
Never use scrub-cutters if housing protector covers are defective, or without the safety mechanism in use.
Never modify the engine speed settings, and do not over-rev the engine.
When trimming, wear a soundproof helmet or ear protectors.
Make sure that the cutting equipment is not engaged when going over gravel or earth paths, and when transporting the equipment
in general.
Avoid cutting near residential areas, pathways and roads or parking areas.
Never allow children or people unfamiliar with these instructions to use this grass cutter.
Never cut pulling the machine towards you.
When transporting the grass cutter other than under its own power, the engine must be switched off.

SPECIFIC MAINTENANCE

IMPERATIF Check before use that the cooling air intake area and engine cylinder are clean and free from any impurity, FAI-
LURE TO COMPLY WHITH THIS REQUIREMENT WILL RENDER THE GUARANTEE NULL AND VOID.
The engine
See the manufacturer's maintenance handbook.
The scrub-cutter
After each use, carefully clean the housing of the cutting equipment and the engine case. Check the state of the cutting
blade, which must always be sharp in order to have as clean a cut as possible and to allow the machine to work at its best.
Attention : If you sharpen the blade, make sure that the blade remains perfectly balanced. After 25 hours of use, lubricate
all moving parts and front and rear wheels. Regularly check all screws, nuts and bolts for tightness.
Gear box
Check the oil level every hundred hours at least. Level should be 2.5 cm (1") below the top edge, when the cap is removed.
Grade of oil : SAE 10W-30, class SG or SF.
MOUNTING THE HANDLEBAR
- Turn the handlebar round, without damaging the cables, position it inside the machine and set
in place using the 2 10x20 bolts (no.1).
1
1
- 22 -
2
3
GB