Transport Wheels (Optional Kit 62293); Grass Catcher - Jacobsen InCommand PGM 22 Manual Tecnico

6.5

TRANSPORT WHEELS (OPTIONAL KIT 62293)__________________________________

!
WARNING
Always stop the engine and disengage the drive
levers before installing or removing the transport
wheels.
1. Push and hold the kickstand against the ground then
pull the mower handle back until the mower rests on
the stand (L).
2. To remove wheels, press retaining clip (J) away
from the hub and pull wheel off hub.
3. To install wheels, set brake, press retaining clip (J),
place wheel on hub, and turn the wheel backwards
until studs on back of wheel line up with holes in
hub (K). Push wheel in and release clip.
4. Always disengage reel clutch lever (E), prior to
transporting the mower more than a few feet.
5. Push the mower forward off the kickstand, start the
engine, and engage the O.P.C. bail (C).
6.6

GRASS CATCHER _________________________________________________________

1. When the basket is about two thirds (2/3) full of grass
clippings, move mower off the green.
2. Stop on a flat surface, disengage all drives, and
stop the engine.
3. Remove and empty the grass catcher. Use a long
handle brush to remove grass clippings from the
mower.
All manuals and user guides at all-guides.com
6. When using a vehicle to transport the mower, apply
parking brake, stop engine, and close fuel shut-off
valve. Chock or block the wheels.
7. Keep tires inflated to 6 to 8 psi (0.41 to 0.55 BAR).
!
To prevent serious injury, always stop the engine,
and disengage all drives before emptying grass
catcher.
OPERATION
K
J
Figure 6D
DANGER
6
L
en-19