Safety Systems; Cleaning - Zummo Z40 Manual Del Usuario

10

SAFETY SYSTEMS

The machine has various safety systems:
1 If the front cover is not assembled or is improperly assembled, the display will show an Error
message with the area of the front cover flashing.
2 If the tray is not assembled or is not in place, the machine will not operate and the display will
show an Error message by displaying a flashing dark tray.
3 If the side covers are not assembled or are improperly assembled, the display will show an Error
message with the area of the side covers flashing.
4 If for any reason the machine gets blocked during operation, after a few seconds the motor will
stop automatically and the display will show an Error message with a faulty flashing icon, until
the cause of the blockage is removed.
5 Thanks to a thermal protection system in the motor, in the event of overheating the machine will
stop and the display will show an Error message and a thermometer icon. In this case, please
wait approximately 10 minutes to allow the motor temperature to decrease. The error message
will disappear. Please check that the ventilation gratings and the fan are not obstructed.
6 If there is no message on the display, it means there is no power supply. Check that the power
switch is on and that the plug fuse is not burnt out (Fig. 31).
11
MACHINE CLEANING
The machine squeezing area and parts must be cleaned daily.
If the machine is in operation, stop it always using the Programmer StoP bottom. Never attempt to stop

the machine using the main switch. Failure to follow this recommendation will cause the machine to stop
in a position that impedes cleaning; possibly leading to breakage of parts due to poor handling.
Disconnect the machine turning the power switch off. (Fig. 6) Then the digital display will turn off. (Fig.

7).
 Remove the cover by releasing it from the sides covers (Fig. 11) and clean it with a cloth moistened in a
neutral soapy solution (IMPORTANT! NEVER clean it with abrasive products which might scratch it).
 Remove the sides covers by pulling gently upwards (Fig. 12a)
19