Installation - Zummo Z40 Manual Del Usuario

 Request technical service to the distribution company that supplied your machine; in the event that you
cannot locate it, contact the factory (data on the cover of this manual).
 The appliance should not be used by people (including children) with limited physical, sensory or mental
capabilities, or lack of knowledge or experience, unless they are properly supervised or have been given
instructions. Children must always be supervised to ensure they do not play with the appliance.
 This appliance is designed to be used for domestic and analogue use, such as:
-Kitchen areas for the staff of shops, offices and other workplaces;
-Farmhouses;
-Guests in hotels, motels and other residential-type establishments;
-Accommodation environments such as hotel rooms.
3

INSTALLATION

 Attention! The machine weighs 81.5 Kg. When moving the machine, we suggest that this should be
accomplished by two people. The best way to lift the machine is to grab the rear of the machine from
underneath, with one hand and with the other hand, grab the shaft from underneath, as well. (Fig. 4)
 Place the machine on a sufficiently sturdy and stable base and secure the machine to the base by M8
screws.
 Make sure that the machine's voltage and frequency match the values of your electrical installation. See
the identification plate. (Fig. 5)
 Use an electrical outlet equipped with an effective ground connection (0.03A). This outlet should be
used exclusively by the juice extraction machine. Do not plug other appliances into the outlet.
 Before operating the machine, wash all machine parts that will be in contact with juice: Balls, Blade,
Juice tray, Filter Tray, Filter and Front Cover.
 Turn ON the power switch (Fig. 6 ( I=On, O=Off )). If no message appears on the display (Fig. 7), there
is lack of power supply. Make sure you have connected the plug to a powered circuit and that the power
switch is switched on. Once this is done, the Programmer display will show one of the following
messages:
a. (Z40 or Z40 Service Model) If the display shows a number (Disp. 1a), the machine is ready to start
operating.
(Self-service Model) If an orange icon is displayed on the digital screen (Disp. 1b), the machine is
ready to operate.
b. If the display shows the Error message (Disp. 2), then the Front Cover is not in place, and it should
be place it correctly.
c. If the display shows the Error message (Disp. 3), the Juice Tray is not correctly assembled and
should be re-assembled correctly.
d. If the display shows the Error message (Disp. 4), the side covers are not correctly assembled and
should be re-assembled correctly.
e. If the display shows the Error MEM (Disp. 5), it means the Programmer is faulty. Contact your local
supplier for technical assistance.
16
(Disp. 1a)
(Disp. 2)
(Disp. 4)
(Disp. 1b)
(Disp. 3)
(Disp. 5)