Important Safety Instructions; Installation - Zummo Z14 Manual Del Usuario

2

IMPORTANT SAFETY INSTRUCTIONS

•
Dear customer: Before starting to use your juicer for the first time, please read this
instructions manual carefully.
•
The machine exerts a great deal of pressure when operating; for this reason, never place
hands or other objects in the squeezing area. (Fig. 9)
•
Always make sure Juice Tray and Cups Fastening Nuts properly are tightened; otherwise,
serious damage to the machine may result. (Fig. 1)
•
Take special care when handling the Blade to avoid the risk of injury. (Fig. 12)
•
To prevent any risks, all repairs should be performed by technical personnel.
•
ZUMMO assumes no liability whatsoever if damage is due to improper machine use or
failure to follow the instructions contained in this manual.
•
Request technical service to the distribution company that supplied you machine; in the
event that you cannot located it; contact the factory (data on the cover of this manual).
3

INSTALLATION

•
Attention! The machine weighs 55 Kg. When moving machine, we suggest that this be
accomplished by two persons. The best way to lift the machine is to use one hand to get a
grip underneath the machine rear and the other hand placed beneath the Squeezing Tray.
(Fig. 6)
•
Place the machine on a sufficiently sturdy and stable base.
•
Make sure that the machine's voltage and frequency match the values of your electrical
installation. See the identification plate. (Fig. 2)
• Use an electrical outlet equipped with an effective earth connection (0.03A). This outlet
should be used exclusively by the juice extraction machine. Do not plug other appliances
into the outlet.
•
Before operating the machine, wash all machine parts that will be in contact with juice;
Balls, Blade, Juicetray, Fliter Tray, Filter and Front Cover.
•
Turn ON the power switch (Fig. 3 ( I=On, O=Off )). If no message appears on the display
(Fig. 4), there is lack of power supply. Make sure you have connected the plug to a
powered circuit and that the power switch is switched on. Once this is done, the
Programmer display will show one of the following messages:
(Disp. 2)
(Disp. 6)
a. If the display shows a number (Disp. 2), the machine is ready to start operating.
b. If the display shows the Error message (Disp. 5), then the Front Cover is not correctly
assembled and should be re-assembled correctly.
c. If the display shows the Error message (Disp. 6), the Juice Tray is not correctly
assembled and should be re-assembled correctly.
d. If the display shows the Error MEM (Disp. 9), it means the Programmer is faulty.
Contact your local supplier for technical assistance.
(Disp. 5)
MEM
(Disp. 9)
15