LAVOR Pro Reno Manual Del Usuario página 18

Usage
• Check that the main switch 6 is (0)
OFF;
• The water inlet hose 19 must be fitted
to the snap-on hose connector.
Caution: use a hose with a minimum
pressure resistance of 1,5 MPa / 200
psi, and an internal diameter of at least
13 mm (1/2").
Caution: Inlet water temperature must
never exceed 40°C;
• Ensure that the high-pressure hose 3
and the hose connector are securely
connected as described in chapter
"Appliance assembly" (photo E-13);
• Screw the mounting 22 tightly by
hand onto the inlet connector.
• Fit the quick-release hose connector 22
onto the garden hose (not supplied).
Fit the hose connector 23 into the
•
mounting 22 .
• Open the tap 18 ;
• Fit the nozzle 15 onto the spray gun
2 . Twist the nozzle clockwise to
secure on the gun;
EN
Put the nozzle 15 on the lance 1 .
•
• Attach the power plug to the socket 17 ;
18
• Switch the machine on by turning the
main switch 6 to (I)ON.
• If the unit motor starts up even without
operating the spray gun 2 , this is
probably due to air bubbles in the
system.
• Press the spray gun lever 23 to purge
any air and residual pressure in the
hosing;
• Fill the detergent tank 4 with
manufacturer approved products,
suitable for the type of job in hand;
• Ensure that the spray gun is
open every time that the unit is turned
on (main switch 6 (I)ON).
Caution: It is hardly suggested to
•
avoid to open and close continuosly
the gun during a brief period of time,
expect for the condition explained
at point 4 at "detergent collection"
section.
Spray gun accessories 2
Caution: Never use the spray gun 2
without an accessory!
(Photo C)
Use of the lance 1
fig. 3A
fig. 3A fig. 3B fig. 3C fig. 3D
The high-pressure cleaner is supplied
with 4 different nozzle types:
Use of the machine in low pressure:
- Low-pressure nozzle (fig. 3A,
"CHEMICAL"- BLACK): for operating with
detergent or cleaning with negligible
pressure,
the mixing of the detergent with
the water is automatic at the water passage
(see "detergent collection" section).
Use of the machine in high water flow:
- 0° nozzle: straight stream (fig. 3B),
this jet allows to clean wide dirty areas
in a simple and quick way; the machine
automatically will provide an itermediate
pressure jet with the max water flow.
Use of the machine in high pressure:
- 15° nozzle: flat spray (fig. 3C)
- 40° nozzle: flat spray (fig. 3D)
These jets allows to remove the hardest
dirt; the machine will work at the max
pressure.
Automatic Stop System
This appliance is equipped with an AS
system. This system immediately starts
the unit whenever the gun trigger 25
is operated and switches it off when the
trigger is released.
• Even though the unit is equipped with
this system, never leave it unattended.
• If the machine is left unused for more
than 5 minutes, turn the main switch
6 to (0)OFF.
Spray gun with pressure gauge 2
The spray gun 2 is equipped with an
integrated pressure gauge. This makes it easy
to check the pressure while you are working.
Spray gun trigger safety catch
The spray gun 2 is equipped with a
manually engaged trigger mechanism lock