Additional Safety Information - LAVOR Pro Reno Manual Del Usuario

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 49
Safety
the machine
from being started unintentionally.
Never direct the jet towards yourself or
any other person to clean clothing or
footwear.
Never allow children or persons
without the necessary skills to operate
the machine.
CAUTION: Do not leave the appliance
in standby mode for more than 5
minutes.
CAUTION: Always switch off the
appliance completely (main switch (0)
OFF) whenever leaving it unattended.
CAUTION: This machine uses high-
pressure fluids. Always grip the gun
2
firmly to counteract the recoil.
Only use the nozzles supplied with the
machine.
CAUTION: The appliance is not to
be used by children or persons with
reduced physical, sensory or mental
capabilities, or lack of experience and
knowledge, unless they have been
EN
given supervision or instruction.
CAUTION: Children being supervised
16
not to play with the appliance.

Additional safety information

Water supply
See chapter "Technical specifications".
Only use clean water.
Water supply connection
Caution - Danger!
Only clean or filtered water should be used
for intake. The water intake should be at
least twice the pump capacity.
-
Minimum delivery rate: 15 l/min
-
Maximum intake water temperature:
40°C
-
Max inlet water pressure: 1MPa
Place the cleaner as close as possible to
the water supply.
Water supply from the water main
Connect a supply hose (not included)
to the water inlet of the unit and to the
water supply.
Open the water supply.
The cleaner can be connected directly to
the mains drinking water supply only if
the supply hose is fitted with a backflow
preventer valve as per current regulations
in force.
Make sure that the hose is at least Ø
13mm and that it is reinforced.
Water supply from an open container
Unscrew the coupling part for the
water inlet.
Screw the suction hose with filter (not
included) onto the water connection
of the unit.
Hang the filter in the container.
Vent the unit before operation.
-
Unscrew the high-pressure line
at the high-pressure outlet of the
unit.
-
Switch on the unit and let it
run until water free of bubbles
emerges at the high-pressure
outlet.
-
Switch off the unit and screw on
the high-pressure hose again.
Caution: Failure to observe the
above conditions will cause serious
mechanical damage to the pump and
will void the guarantee.
High-pressure hose
Caution: The high-pressure hose
has been specially designed to resist
high pressures. Treat with particular
care to prevent damaging it.
Avoid tangling.
Do not bend the hose or subject it to
high stress or strain
Never start the high-pressure cleaner
without first completely unwinding
the high-pressure hose
Before unwinding or winding the
hose, switch the machine off and
release the pressure in the hose
itself (pull spray gun trigger 25 2-3
times).
Caution: Inappropriate use may cause
damage or untimely breakage and
voids the guarantee.
3
3 .
loading