Polycut 2-2 Mowing Head; Mounting The Loop Handle - Stihl FSA 45 Manual De Instrucciones

7 Assembling the Trimmer
The line limiting blade (1) is already installed in
the deflector (2) and must not be removed.
► Push the deflector (2) into the guides on the
housing as far as stop.
The deflector (2) is tight against the housing.
► Insert and tighten down the screws (3) firmly.
The deflector (2) must not be removed again.
7.2

PolyCut 2-2 Mowing Head

7.2.1 Fitting Mowing Lines
► Switch off the trimmer and remove the activa‐
tion key.
► Place mowing lines in a container filled with
water for 12 to 24 hours before using.
This makes the nylon mowing lines supple.
1
► Push mowing line up through the right opening
from below.
► Thread the mowing line through the left open‐
ing from above until the end of the line rea‐
ches the symbol.
► Hold the short end of the mowing line firmly.
► Pull the long end of the mowing line until it is
tight against the mowing head.
► Cut the mowing lines so that they extend as
far as the line limiting blade.
7.2.2 Removing Mowing Lines
► Switch off the trimmer and remove the activa‐
tion key.
► Push the short end of the mowing line
upwards out of the mowing head.
► Pull the short end of the mowing line upwards
out of the mowing head.
► Pull the mowing line out of the mowing head.
0458-718-9821-C
2
7.2.3 Mounting the Blades
► Switch off the trimmer and remove the activa‐
tion key.
► Place blades in a container filled with water for
12 to 24 hours before using.
This makes the blades supple.
2
1
1
► Position the blade (1) on the mowing head so
that the bushing (2) locates in the large bore in
the blade (1).
► Pull the blade (1) outwards until the bushing
(2) engages the small bore in the blade (1).
7.2.4 Removing the Blades
► Switch off the trimmer and remove the activa‐
tion key.
30°
2
1
► Push the blade (1) inwards until the bushing
(2) is released from the small bore in the blade
(1).
► Remove the blade (1) upwards.
7.3

Mounting the Loop Handle

► Switch off the trimmer and remove the activa‐
tion key.
1
► Position the loop handle (2) so that the recess
for the star knob nut (1) is on the right –
viewed from the control handle.
English
2
2
3
29