Tabla de contenido
Idiomas disponibles
Idiomas disponibles
7. Canopy Assembly.
Locate 2 screws on underside of hanging bracket
and remove screw closest to the open end of the
hanging bracket. Partially loosen the other screw.
Lift canopy to hanging bracket. Place rounded
part of slotted hole in canopy over loosened screw
in hanging bracket and push up. Twist canopy to
lock. Re-insert screw that was removed, and then
tighten both screws securely. Slide canopy cover
up to canopy, aligning rounded part of slotted
holes in canopy cover with screw heads in bottom
of canopy. Turn canopy cover to right (clockwise)
until it stops.
8. Blade Assembly.
Time Saver: Washers for blade screws can be
set on each blade screw prior to installing
blades.
Locate 15 blade attachment screws and
washers in hardware pack. Slide blade
through one of the narrow, rectangular
openings on motor housing, aligning holes
in blade with holes in blade arm (located on
the underside of the motor housing)--refer
to drawing at right. (Be sure to install blades
with ridged-side facing up and flat side
facing the floor).
Then, place blade plate
under holes in blade, making sure to align all
3 holes, as shown in drawing at right.
blade attachment screws (along with
washers) with fingers first and then tighten
screws securely with a Phillips screwdriver.
Repeat procedure for each remaining blade.
Note: Tighten blade attachment screws
twice a year.
All manuals and user guides at all-guides.com
motor housing
Insert 3
page 7
screw
canopy
canopy cover
hanging bracket
screw
blade
arm
blade
blade plate
blade attachment
screws and washers
Capítulos
Tabla de contenido
