Protection Systems; Emissions - Generac 0060550 El Manual Del Propietario

Protection Systems

The generator may have to run for long periods of time
with no operator present to monitor the engine/generator
conditions. Therefore, the generator is equipped with a
number of systems to automatically shut down the unit to
protect it against potentially damaging conditions. Some
of these systems are as follows:
Alarms:
• High Temperature
• Low Oil Pressure
• Overcrank
• Overspeed
•
Overvoltage
• Undervoltage
• Overload
Warnings:
• Charger Warning
•
Charger Missing AC
• Low Battery
• Battery Problem
The control panel contains a display which alerts the
operator when a fault condition occurs. The above list is
not all inclusive. For more information about alarms and
control panel operation, see Operation.
NOTE: A warning will indicate a condition, on the
generator, that should be addressed but not shut the
generator down. An alarm will shut the generator down to
protect the system from any damage. In the event of an
alarm, an owner can clear the alarm and restart the
generator prior to contacting an Independent Authorized
Service Dealer. If the intermittent issue occurs again,
contact an Independent Authorized Service Dealer.
NOTE: For Synergy-specific alarms, see
Troubleshooting.
Owner's Manual for 60 Hz Synergy Generator™
• Underspeed
• RPM Sensor Loss
• Controller Fault
• Wiring Error
•
Fuse Problem
• Stepper Overcurrent
• Exercise Set Error
•
USB Warning
• Download Failure
General

Emissions

The United States Environmental Protection Agency (US
EPA) (and California Air Resources Board (CARB), for
engines/equipment certified to California standards)
requires that this engine/equipment complies with
exhaust and evaporative emissions standards. Locate
the emissions compliance decal on the engine to
determine applicable standards. For emissions warranty
information, please reference the included emissions
warranty. It is important to follow the maintenance
specifications in the manual to ensure that the engine
complies with the applicable emissions standards for the
duration of the product's life.
This generator is certified to operate on Liquid Propane
Vapor fuel or pipeline Natural Gas.
The Emission Control System code is EM (Engine
Modification). The Emission Control System on this
generator may consist of the following components:
Air Induction System
• Intake Pipe / Manifold
• Air Cleaner
Fuel Metering System
• Carburetor / Mixer
Assembly
• Fuel Regulator
General Information
Ignition System
• Spark Plug
• Ignition Module
Exhaust System
• Exhaust Manifold
•
Muffler
7