Tabla de contenido
Idiomas disponibles
Idiomas disponibles
WARNING:
Batteries can explode or leak, and can cause injury or fire.
To reduce this risk, follow the instructions in the Battery
Safety Manual.
Storing Battery Packs
• The best storage place is one that is cool and dry, and away from
direct sunlight and excess heat or cold.
• Long storage will not harm the battery pack or charger. Under
proper conditions, they can be stored for 5 years or more.
SAVE THESE INSTRUCTIONS FOR FUTURE USE
Installing the Coin Cell Battery
A coin cell battery should already be installed in the bottom of
the laser unit (Figure
) so it is ready to use the Bluetooth
D 3
connection, after you remove the battery protector. To remove the
battery protector on your new laser, or replace the coin cell battery in
the future, follow these steps.
Carefully turn the laser upside down.
1.
On the bottom of the laser, unscrew the battery compartment cover,
2.
which is marked 3V CR2430.
Lift off the battery compartment cover and remove the coin cell
3.
battery.
If your laser is new, remove the battery protector (round disc), and
4.
then re-insert the same coin cell battery.
If your laser is not new, insert a new 3V CR2430 coin cell battery into
5.
the battery compartment.
Carefully place the battery compartment cover back in the correct
6.
position and use the screws to secure the cover in place on the
bottom of the laser unit.
THE BLUETOOTH
WORD MARK AND LOGOS ARE REGISTERED TRADEMARKS OWNED
®
BY BLUETOOTH SIG, INC. AND ANY USE OF SUCH MARKS BY DEWALT IS UNDER LI-
CENSE. APPLE AND THE APPLE LOGO ARE TRADEMARKS OF APPLE INC., REGISTERED
IN THE U.S. AND OTHER COUNTRIES. APP STORE IS A SERVICE MARK OF APPLE INC.,
REGISTERED IN THE U.S. AND OTHER COUNTRIES. GOOGLE PLAY AND THE GOOGLE
PLAY LOGO ARE TRADEMARKS OF GOOGLE INC.
Installing Batteries in the Remote
Load new AAA batteries into the remote so you can use it with the
laser unit.
On the bottom of the remote, lift up the latch to open the battery
1.
compartment cover (Figure
Insert two new, high-quality, name brand AAA batteries, making
2.
sure to position the - and + ends of each battery as noted inside the
battery compartment (Figure
Push the battery compartment cover closed until it snaps into
3.
place (Figure
C 3
Charging the Detector
The Digital Laser Detector is powered by a Li-ion battery. To charge
the battery.
®
Insert the USB end of the charging cable into a USB port (Figure
1.
).
E 1
On the Detector, pull the Micro USB port cover (Figure
2.
and to the side.
Insert the Micro USB end of the charging cable into the
3.
Detector's Micro USB port (Figure
Allow the Detector time to fully-charge. The LED on the Detector
4.
will remain Red as the battery is charging (Figure
When the LED on the Detector turns Green, remove the
5.
charging cable.
The RBRC® Seal
The RBRC® (Rechargeable Battery Recycling
Corporation) Seal on the nickel cadmium, nickel metal
hydride or lithium-ion batteries (or battery packs)
indicates that the costs to recycle these batteries (or
battery packs) at the end of their useful life have already
been paid by D
WALT. In some areas, it is illegal to
e
place spent nickel cadmium, nickel metal hydride
or lithium-ion batteries in the trash or municipal solid waste stream and the
Call 2 Recycle® program provides an environmentally conscious alternative.
).
C 1
).
C 2
).
).
E 3
E
) off
E 2
).
F
13
15
Tabla de contenido
