Connecting To The Power Supply; Using The Beertender; Inserting A Beertender ® Keg - Krups BeerTender VB31 Manual De Instrucciones

CONNECTING TO THE POWER SUPPLY

Electricity can be dangerous! Therefore you must always scrupulously abide by the safety
rules.
„ The appliance must be plugged into a suitable, properly installed electric socket.
„ The voltage of the appliance has been set in the factory. Check that the mains voltage
matches the voltage indicated on the rating plate on the rear of the appliance.
„ Make sure the main switch on the rear of the machine is set to "0" before connecting the
Beertender to the mains. Insert the plug into a socket with the correct voltage and turn on
®
the appliance by moving the main switch to "I" - fig. 10.
The appliance will immediately start cooling the inner chamber as soon as the main switch is
set to "I".

USING THE BEERTENDER

INSERTING A BEERTENDER
„ Note: the Beertender
containing beer sold by the Heineken group.
„ The appliance can only be used if it contains a Beertender
is set to "I".
„ The LED on the left side of the control panel, when illuminated, tells you that the appliance
is switched on.
„ You can open the appliance by pressing the handle on top of the lid. When the handle is
released, you can lift the lid up - fig. 11-12.
Note: do not force the lid beyond the set opening position as this could damage it.
„ When the lid is completely open, insert a Beertender
„ Remove the upper part of the dispensing head (6) by lifting it upwards as indicated in the
illustration - fig. 14.
Note: this cover can be removed for cleaning.
„ Install the Beertender
Note: Do not try to actuate the tap of the Beertender
„ Position the beer tube as shown on drawing - fig. 15.
„ Return the upper part of the dispensing head in its initial position.
Note: The upper part of the dispensing head cannot be repositioned (fig. 16) if the Beertender
keg tap has not been properly set up.
„ Ensure that the upper part of the dispensing head is positioned in the beer pump mechanism
before closing the lid.
„ Ensure that the positioning of the upper part of the dispensing head conforms to the one in
the illustration so as not to damage the beer pipe - fig. 16.
„ Gently close the appliance lid again until it lock - fig. 17.
SYSTEM
®
KEG
®
may only be used with Beertender
®
keg tap.
®
Kegs "Compatible Beertender
®
Keg and only if the main switch
®
Keg as shown in the figure - fig. 13.
®
Keg by hand.
®
English
"
®
®
9