Screw For Securing Unit (M6 × 55) - Panasonic TY-ST65PB2 Instrucciones De Montaje

Assembly
3. Fitting to the stand
Note
Before fitting the display, make sure to lock all 4 casters.
1. Fitting the display
① Engage the upper insulation spacers of the
display with the cutouts at the top of the mobile
stand, and slowly lower the display into place.
② While lifting the display slightly, insert the bottom
insulation spacers into the holes at the lower end
of the mobile stand, and then lower the display
straight down into place.
CAUTION
Do not lift up the display higher than
necessary.
• If the display is lifted too high, it may fall down
and personal injury may result.
2. Fixing the display
Firmly tighten the screws (2) for securing unit
Ⓗ in the screw holes on the upper part of the
mounting bracket (2).
(Tightening torque: 1.2 to 1.5 N·m)
Note
Make sure to fit the screws for securing unit Ⓗ on the
left and right to prevent the display from coming off.
20
Locking and unlocking the casters
Caster locked
Lower the lever
Upper insulation spacer
①
Hole in the upper part
Lower insulation
Holes for screws for securing unit
Screw for securing unit Ⓗ
Caster unlocked
Lift the lever
②
spacer
Hole in the lower part