Switching Off The Device - Steinbach APPcontrol Manual Original

- Place the control unit in the shade, if possible.
1. Only let as much of the floating cable
all the spots in the pool.
2. Connect the plug of the floating
cable in the right position to the
6
control unit
3
connection together.
3. Attach the control unit
of at least A=3.5 m to the pool with the
safety rope
5
pulled into the water.
4. Connect the power plug to a grounded
socket.
The control unit is connected.
Starting cleaning
1. Press the ON/OFF button on the control unit.
The display indicates the settings of the last selected cleaning program.
2. Select the desired type of cleaning and adapt the running time to the size of your
pool.
3. Press the ON/OFF button again to start the set cleaning program.
Cleaning starts and the running time LED starts to blink.

Switching off the device

Proceed as follows to switch off the device:
1. Switch off the device after the end of the cleaning program.
2. Disconnect the control unit from the power supply and the device.
3. Lift the device out of the pool.
4. Clean the filter units and the device.
5. If you use the autostart function, place the device in the pool again and connect the
control unit to the power supply.
and screw the
at a distance
3
so that it cannot be
into the water so that the device can reach
6
6
7
5 3
3
6
A
47