Switching Off The Device - Steinbach Poolrunner Battery+ Manual Del Usuario

2. Hold the device by the handle
lower it slowly into the water until all
the air has escaped. The device should
run at a right angle to the pool wall.
3. Set the rotary switch
The device switches itself on
automatically as soon as it is fully
immersed in the water. The status
indicator is lit blue.
10
4. Afterwards, carefully lower the device
on the nylon cord to the bottom.
The device is in the pool and starts cleaning
with a time delay. The status indicator
blinks blue.
Cleaning stops automatically when the rechargeable battery is almost drained. The status
indicator is lit red. The device moves to the pool wall.
10

Switching off the device

Proceed as follows to switch off the device:
1. Lift the device out of the pool and switch it off.
2. Clean the filter unit and the device.
Lifting the device out of the pool
The pump of the device can be damaged if it is switched on or off
outside of the water.
- Only switch the device on or off when it is located below the
water surface.
1. Slowly pull the device to the surface by the floating handle and the nylon cord until
you can reach the handle.
2. Set the rotary switch to OFF.
40
and
11
to ON.
8
10
NOTICE!
13
14
8
10