Measuring Object Temperature/Room Temperature; Error Messages - Beurer FT 85 Instrucciones De Uso

9. Measuring object temperature/room temperature

If you want to measure an object temperature with this thermometer, switch to object tem-
perature mode.
• With the thermometer switched on, briefly press the MODE/MEM button. The device
switches to the object temperature mode (Fig. 14).
• Hold the thermometer 2 to 3 cm from the measuring point. Briefly press the
button and read the temperature on the display (Fig. 15).
The device automatically switches off after approx. 60 seconds or you can press the
/ SCAN button for 5 seconds to switch it off.
Measurements taken in object temperature mode are not stored.
If you want to use the thermometer to measure the room temperature you need to switch to room tem-
perature mode.
• With the thermometer switched on, briefly press the MODE/MEM button twice.
The device switches to room temperature mode
• The room temperature is immediately displayed (Fig. 16).
The device automatically switches off after approx. 60 seconds or you can press the
5 seconds to switch it off.
Measurements taken in room temperature mode are not stored.

10. Error messages

Error mes­
Problem
sage
Measurement during self-test, device not yet ready for
measurement.
Room temperature below 15 °C or over 40 °C (<59 °F,
>104 °F).
.
Solution
Wait until the forehead symbol stops flashing.
Room temperature must be between 15 °C and 40 °C
(59 °F – 104 °F).
34
/ SCAN
Fig. 14
/ SCAN button for
Fig. 15
Fig. 16