Surface Temperatures; Ambient Temperature - Beurer JFT 60 Instrucciones Para El Uso

Tabla de contenido
Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 27
Apply the thermometer to the left or right temple and press the "SCAN" button. Move the thermometer to
and over the temple. During the measurement you can hear short beeps signalling that the thermometer
has found a new maximum temperature. The end of the measuring time is signalled with a long beep. Re-
lease the "SCAN" button. You can now read off the temperature measured. The LED is also illuminated
according to the test result: a green LED indicates that body temperature is within the normal range, but
a red LED lights up with measured values over 37.5 °C, i.e. it is a fever alarm. The measurement normally
takes from 5 to 8 seconds, but can take up to 30 seconds.
The thermometer signals with two short beeps and a no longer flashing forehead symbol that the thermometer is ready for
a new measurement.
6.2 Saving the temperatures measured
The temperature last measured, i.e. only the last temperature of a series measured, is saved automatically as soon as the
thermometer is switched off. There are 9 memory locations available for this.
You can call up the last temperature measured with the " " button. The date and time are also shown. The LED does not
support any requests for stored measured values. If you continue to hold down the " " , you will enter a special measu-
ring mode, in which the thermometer will not make a correct measurement. In this event, allow the thermometer to switch
off automatically after about 1 minute and then switch it on again.

6.3 Surface temperatures

When you want to measure surface temperatures with this infrared thermometer, you must change to the "SCAN" mode.
With the thermometer switched on (standard forehead thermometer mode) keep the " " button depressed and at the
same time press the "SCAN" button. This mode is indicated with the
symbol. If you keep the "SCAN" button de-
pressed, the surface temperature measured is continuously displayed. You can apply the sensor tip directly to the surface
to be measured or measure at close range (do not immerse in liquids).
Note that the temperature displayed is the surface temperature measured but not adjusted. It cannot be compared with
the forehead temperature.

6.4 Ambient temperature

After the measurement, the thermometer automatically switches to standby mode after about 1 minute, but only if the
time has been set. This mode is identified by the
symbol and the ambient temperature is shown continuously.
If you want to use the thermometer to measure the ambient temperature, it should be positioned so that the measurement
15
Tabla de contenido
loading

Este manual también es adecuado para:

Ft 60

Tabla de contenido