Tabla de contenido
Idiomas disponibles
Idiomas disponibles
STARTINg ANd STOPPINg ThE SAw
Make sure that the switch is in the
"OFF" postion. To reduce the risk of
injury, turn unit off and disconnect it from power source
before installing and removing accessories, before
adjusting or when making repairs.
An accidental start-up can cause injury.
kEEP MAChINE CLEAN
Periodically blow out all air passages with dry
compressed air. All plastic parts should be cleaned with
a soft damp cloth.
NEvER use solvents to clean plastic parts. They could
possibly dissolve or otherwise damage the material.
Wear certified safety equipment for eye,
hearing and respiratory protection while
using compressed air
In spite of how well a band saw is maintained, problems can occur. The following troubleshooting guide will help you
solve the more common problems:
TROUBLE: SAW WILL NOT START.
Probable Cause
1. Saw not plugged in.
2. Fuse blown or circuit breaker tripped.
3. Cord damaged.
TROUBLE: BREAKER KICKS OUT FREQUENTLY.
Probable Cause
1. extension cord too light or too long.
2. Feeding stock too fast.
3. Blade in poor condition (dull, warped, gummed).
4. Low voltage supply.
TROUBLE: BAND SAW VIBRATES EXCESSIVELY.
Probable Cause
1. Machine not mounted securely to stand.
2. Stand on uneven surface.
3. worn belt.
4. Pulley not aligned.
5. Motor not fastened securely.
MAINTENANCE
FAILURE TO START
Should your machine fail to start, check to make sure
the prongs on the cord plug are making good contact
in the outlet. Also, check for blown fuses or open
circuit breakers in the line.
LUBRICATION & RUST PROTECTION
Apply household floor paste wax to the machine table,
extension table or other work surface weekly. Or use a
commercially available protective product designed for
this purpose. Follow the manufacturer's instructions for
use and safety.
To clean cast iron tables of rust, you will need the
following materials: a sheet of medium Scotch-Brite™
Blending Hand Pad, a can of WD-40® and a can of
degreaser. Apply the WD-40 and polish the table
surface with the Scotch-Brite pad.
Degrease the table, then apply the protective product
as described above.
TROUBLEShOOTINg
Remedy
1. Plug in saw.
2. replace fuse or reset circuit breaker.
3. have cord replaced.
Remedy
1. replace with adequate size cord.
2. Feed stock more slowly.
3. Clean or replace blade.
4. Contact an electrician
Remedy
1. Tighten all mounting hardware.
2. reposition on flat level surface.
3. replace belt.
4. Adjust pulleys.
5. Tighten all mounting hardware.
16
Tabla de contenido
Solución de problemas
