Setting Up The Transmitter; Connecting A Microphone - AKG WMS40 Modo De Empleo

Fig. 3: Inserting batteries
14
2. Pull the battery compartment lid (6)
down to remove it from the trans-
mitter.
3. Insert the supplied batteries into the
battery compartment conforming to
the polarity marks.
The transmitter will not function with
incorrectly inserted batteries.
4. Set the on/off switch (1) to "ON" to
switch the power to the transmitter on.
The status LED (2) will flash momen-
tarily. If the batteries are in good con-
dition, the status LED (2) will extin-
guish.
If the status LED (2) illuminates the
batteries will be dead within about 50
minutes. Replace the batteries with
new ones as soon as possible.
If the status LED (2) fails to flash
momentarily the batteries are dead.
Insert new batteries.
5. To close the battery compartment,
slide the battery
lid (6) onto the battery compartment
from below to the point that it will
click shut.

3.3 Setting Up the Transmitter

3.3.1 Connecting a Microphone

The PT 40 bodypack transmitter has
been designed primarily for use with "L"
type MicroMic Series microphones from
AKG (see section 2.7). If you wish to
connect other microphones from AKG or
other manufacturers to the PT 40, plea-
se note that you may have to rewire the
existing connector of your microphone
or replace it with a 3-pin mini XLR
connector.
Audio input pinout:
Pin 1: shield
Pin 2: audio (inphase)
Pin 3: supply voltage
compartment