Controls; Fcc Statement; Electromagnetic Compatibility (Emc); Tool Assembly - RIDGID micro CA-100 Manual De Instrucciones

micro CA-100 Inspection Camera

Controls

Rotate
Image
LED Brightness
Decrease
Figure 2 - Controls

FCC Statement

This equipment has been tested and found
to comply with the limits for a Class B digital
device, pursuant to part 15 of the FCC Rules.
These limits are designed to provide reason-
able protection against harmful interference
in a residential installation.
This equipment generates, uses, and can
radiate radio frequency energy and, if not
installed and used in accordance with the
instructions, may cause harmful interference
to radio communications.
However, there is no guarantee that interfer-
ence will not occur in a particular installa-
tion.
If this equipment does cause harmful in-
terference to radio or television reception,
which can be determined by turning the
equipment OFF and ON, the user is encour-
aged to try to correct the interference by one
or more of the following measures:
na.
equipment and receiver.
dio/TV technician for help.
Electromagnetic
Compatibility (EMC)
The term electromagnetic compatibility is
taken to mean the capability of the prod-
uct to function smoothly in an environment
where electromagnetic radiation and elec-
6
trostatic discharges are present and without
causing electromagnet interference to other
equipment.
NOTICE
The RIDGID micro CA-100 Inspec-
tion Camera conforms to all applicable EMC
standards. However, the possibility of it caus-
ing interference in other devices cannot be
precluded.

Tool Assembly

Battery
Indicator To reduce the risk of serious injury during
use, follow these procedures for proper as-
Power
sembly.
LED Brightness
Increase

Changing/Installing Batteries

The micro CA-100 is supplied without batter-
ies installed. If the battery indicator displays
red , the batteries need to be replaced.
Remove the batteries prior to long term stor-
age to avoid battery leakage.
1. Squeeze the battery clips (See Figure 3)
and remove battery compartment from
the micro CA-100 Inspection Camera
(See Figure 4). If needed, remove batter-
ies.
Figure 3 - Battery Compartment Cover
-
2. Install 4 new AA alkaline batteries (LR6),
observing the correct polarity as indi-
cated on the battery compartment. Only
replace in sets to help prevent battery
leakage.
-
3. Squeeze the clips and firmly insert into
inspection camera. The holder will only
go in one way. Do not force. Confirm se-
curely attached.
WARNING