HoMedics enviraScape Manual De Instrucciones página 7

WFL-SLVSA-2EU_IB.qxd:Layout 1
MAINTENANCE :
To clean the pump:
Unplug from electrical
outlet. Remove it from the
base of the fountain. Use
a small brush or stream
of water to remove any
debris (Fig 9).
To keep water
clean:
Periodically change
water and clean the
product according to the
water condition. Keeping
the water clean prevents
the water from becoming
sticky and forming
micro-organisms.
To clean off hard water deposits on the base or rocks:
Soak the container and rocks in a mixture of vinegar and water to clean and remove any mineral
build-up.
Keeping the water at an optimum level:
Add water periodically to keep water level at an optimum level to avoid shortening the life of the
pump.
NOTE: Never let the pump run dry, as this will shorten the life of the pump.
Fountain Storage
Unplug the fountain from the electrical outlet, empty the water, and store rocks and fountain in a
dry, cool place.
Changing Light bulb
First unplug fountain and let bulb cool down. Remove the bulb cover by holding glass bulb
cover in dry hand and rubber neck with other hand. Slowly pull apart. Slight twisting may help to
loosen. Be gentle with bulb cover since it is glass. Never pull on cord. Next pull bulb straight out
and replace with new bulb, inserting prongs into the holes. Replace bulb cover securely.
Plug (MODEL WFL-ROC-3GB ONLY)
If the plug on this appliance is damaged, it can be replaced
with a BS 1363 plug, fitted with a 3A BS 1362 fuse.
Only use a 3amp fuse with this appliance.
Care must be taken when changing the plug.
If in doubt, contact a qualified electrician.
9/11/10 15:06
Figure 9
Pump Inlet
Front Plate
Flow
Control
Lever
7
Page 7
PVC Tubing
Inserts Here
Impeller
Suction Feet
Back Plate
Housing