Install The Dc Sensor - Kohler K-10668 Manual Del Usuario

Ocultar thumbs Ver también para K-10668:
Tabla de contenido
Idiomas disponibles

Idiomas disponibles

Cap
DC Sensor
Connector
Screw

Install the DC Sensor

NOTICE: Do not pinch or kink the wires between the cap and the
valve body. If the wires are damaged, the unit may not operate.
Hold the cap vertically with the sensing holes down and align the
DC sensor with the cap.
Slide the DC sensor into the cap until the sensor eye aligns with
the hole in the cap. Ensure the sensor wires are not pinched.
Place the sensor strap over the DC sensor and tighten the screws
in the cap until snug.
Connect the DC sensor connector to the solenoid connector on the
valve. Ensure that the connector pair is fully seated.
Locate the connector assembly adjacent to the battery to prevent
pinching when the cap is reinstalled on the valve.
Place the cap on the valve body.
Secure the cap with the setscrew.
Open the control stop valve (refer to the "Control Stop Valve
Operation" section).
Reinstall the stop cap onto the control stop and tighten firmly
with a strap wrench.
Verify that the valve functions.
Kohler Co.
Setscrew
DC Sensor
Sensor Strap
9
1140767-5-A
Tabla de contenido
loading

Tabla de contenido