Sony HT-IS100 Manual De Instrucciones página 26

Performing the Auto
Calibration
THEATER TV INPUT
TV
BD
SOUND FIELD VIDEO
BD/DVD
TOP MENU MENU
JUMP PICTURE
1 2
4 5
7 8
0
CLEAR
DISPLAY
F
C, X, x, c,
G
f
RETURN/EXIT
TV CH -
PRESET - REPLAY ADVANCE
. <
TUNING -
m
TV
1
?/1
Press .
The system turns on.
2
Press AMP MENU.
Point the remote at the remote sensor ( ) on
the remote commander receiver.
Remote sensor
Remote commander receiver
3
x/X
Press repeatedly until "A. CAL
MENU" appears on the top panel
display, then press
26
US
TV ?/1
?/1
AV ?/1
?/1
SYSTEM STANDBY
DVD
SAT
Input
TUNER/BAND DMPORT
buttons
F1 F2
WIDE FAVORITE
GUIDE
3
TONE
6
NIGHT
MODE
9
AMP
AMP MENU
MENU
ENTER
TOOLS/
OPTIONS MUTING
MUTING
TV VOL
MASTER VOL
g
MENU/HOME
TV CH +
PRESET +
< >
TUNING +
H M
X x
or c.
4
x/X
Press to select "A. CAL START,"
then press .
The Auto Calibration starts after the
countdown.
The measurement process will take
approximately 30 seconds to complete.
The table below shows the display when
measurement starts.
Measurement for
Speaker existance
Speaker gain, distance, frequency
response
Subwoofer gain and distance
Notes
• If "PHONES" appears, you cannot perform the Auto
Calibration. Disconnect the headphones from the S-
AIR product you are using, then restart the Auto
Calibration.
• If "CHECK MIC" appears, you cannot perform the
Auto Calibration. Connect the calibration mic, then
restart the Auto Calibration.
Tip
• When the Auto Calibration starts:
– Stand some distance from the speakers and the
listening position to avoid measurement failure. This
is because test signals are output from the speakers
during measurement.
– Avoid making noise to get a more accurate
measurement.
To cancel the Auto Calibration
The Auto Calibration function will be canceled
when you do the following during the
measurement process:
– Press MUTING.
– Press input buttons on the remote or INPUT
SELECTOR on the subwoofer.
– Change the volume level.
Display
TONE
T.S.P.
SUBWOOFER