Circuit Breaker - Utilitech 0003139 Manual De Instrucciones

SAFety iNForMAtioN
15. During installation, cover well to prevent foreign matter from contaminating the well or later
damaging the pump during operation. Test well water for purity. Chlorination may be necessary.
Check local health department for proper testing and recommendations.
16. Hand pump new wells until clear. Sand or other sediment will seriously damage the pump.
17. The following may cause severe damage to pump and/or piping and will void warranty:
• Failure to protect pump and piping against below-freezing temperatures.
• Pumping chemicals or corrosive liquids.
• Running the pump dry. Follow priming instructions, depending on the installation.
18. Do NOT use extension cords.
19. Do NOT pump gasoline or other flammable liquids.
20. Do NOT use this pump in or near a swimming pool, lake or pond.
iMportANt: SeLect correct VoLtAGe
WArNiNG: Disconnect pump from power source before changing the pump
voltage. The selector switch is located underneath the plastic cover on top
of the motor. To access the switch, remove the four screws holding the
plastic cover. To change the voltage setting, slide the switch as shown until
desired voltage is visible on the switch. The voltage number that appears is
the voltage setting for the pump. Be sure the switch is completely engaged.
Replace the terminal box cover and secure the cover with the four screws.
Do not overtighten the screws.
Wire Selection Guide
iteM horSe
# poWer
0003139
1/2
0003124
0003125
1
FuSe AND circuit BreAKer SiZe GuiDe
horSe-poWer
1/2
3/4 & 1
*For circuits not over 150 volts to ground.
NAMe-pLAte
VoLtAGe
AMpS
115 7.1
230 3.6
115 10.2
StANDArD LiNe
pLuG FuSe*
115V 230V
20 10
30 15
MAX Wire LeNGth iN Feet uSiNG AWG SiZe
#14 #12
118 189
475 756
84 135
LOW PEAK - CART. TYPE
FUSETRON - CART. TYPE
FUSTAT - PLUG TYPE*
115V 230V
12 6-1/4
20 10
5
#10 #8
296 464
1184 1857
211 331

circuit BreAKer

115V 230V
20 15
30 15