Utilitech 0955646 Guia De Inicio Rapido

SUBMERSIBLE UTILITY PUMP
QUICK START GUIDE. SEE INSTRUCTION
MANUAL FOR COMPLETE DETAILS.
2. Place pump
(A) in the water
on a hard
surface. Pump
(A) will operate
continuously
whether
partially or fully
submerged. Avoid
placing pump (A)
directly on sand,
dirt, or mud.
Pump (A) has an
4.
air valve to prevent
air-locking. Air-
locking will keep
pump (A) from
pumping water.
A small spray of
water from the air
valve is normal and
does not represent
a defective pump.
6. DO NOT RUN
DRY. Running
pump (A) when it
is not submerged
in water will
damage the seal
and impeller,
and void the
warranty.
ITEM #0955646, 0955647
MODEL #148001, 148002
A
Hard
Surface
Normal
Water
Spray
A
A
DO NOT
RUN DRY!
1. Attach garden hose
adapter (B) to the pump
(A) discharge and then
connect garden hose (not
included) to adapter (B).
DO NOT OVERTIGHTEN
THE GARDEN HOSE OR
HOSE ADAPTER. Hand
tight plus an additional
1/4 to 1/2 turn should be
sufficient.
Plug pump (A)
3.
into a properly
grounded 115 V
AC power outlet.
5. When the water
level at bottom of
pump (A) drops
to approximately
3/16 in., pump (A)
will continue to run
but will stop mov-
ing water. Unplug
pump (A) when
water stops flowing
from the hose.
IL1774A
WARNING:
FOR YOUR PROTECTION, ALWAYS
DISCONNECT PUMP FROM POWER
SOURCE BEFORE HANDLING.
NOT DESIGNED FOR CONTINUOUS,
ONGOING OPERATION. DESIGN LIFE IS
4,500 ACCUMULATED HOURS.
B
A
IL1772
GFCI Outlet
A
RESET
Unplug
TEST
Pump
A
Low Water
Printed in China
SW1108 A