Campingaz Xcelerate 600 SV Instrucciones De Empleo página 12

To relight the burner put the knob at the
•
OFF '' '' position and follow the instructions
in the paragraph below.
GB
Lighting a burner with flame safety device
(STOPGAz)
STOPGAZ
- Open the gas supply (valve or lever on
regulator).
- Rotate the knob corresponding to the
burner anti-clockwise to the maximum flow
rate position (
- Wait 2 to 3 seconds and press the
piezoelectric knob (
until the burner lights, whilst holding the
adjustment knob in.
Important: the device must not be used
for more than 15 seconds.
- If the burner does not light after 3 tries, turn
the adjustment knob to the "OFF" position
•
( ) and repeat the operation.
- If after these 15 seconds the burner has not
let, stop using the device, reset the knob to
the "OFF" position (
minute before any new attempt to light the
burner.
Once the burner has lit, hold the adjustment
knob down for 10 seconds, then adjust the
flame to the dimension of the container
being used by positioning the knob in the
defined range between (
In strong winds arrange the appliance so
that the lid provides an obstacle to the
wind. Furthermore, your appliance has
a new patented, high wind performance
Campingaz
®
with a pan support (patented) playing the
role of 360° windshield.
- When cooking is finished turn the knob
corresponding to the burner clockwise to
).
) several times
•
) and wait at least one
) and (
"xcelerate burner" combined
•
position ( ).
IMPOrTANT: Never close the appliance
lid without checking that all the burners are
off, the valves closed and the appliance has
cooled down.
F - REMOVING OR CHANGING THE
GAS CYLINDER
- Check that the gas cylinder valve or
regulator lever is in the closed position.
- Place the adjusting knobs in position (
turning them clockwise.
- Disconnect the regulator from the gas
cylinder.
- Install the new gas cylinder.
- Connect the regulator to the new gas
cylinder (check the condition of the
regulator seal, before connecting it to the
gas cylinder).
G - STORAGE - SERVICING
In case of burn back (ignition under the
burner cap) switch the product off, allow it
to cool down (approximately five minutes),
then reignite the appliance. If the problem
of burn back persists, then please contact
your local Campingaz® representative.
Once your equipment has fully cooled
1) Appliance
Ensure that your stove is regularly maintained,
and it will give you many years of excellent
service.
- Do not clean the stove while it is in
operation. Wait for it to cool down, to avoid
burning yourself on the hot parts (hotplates,
pan supports, burners).
).
- Check that the burner Venturi tubes on
the injector are not obstructed by dust or
cobwebs.
- While cleaning, take care not to obstruct the
burner holes. If the holes should be blocked,
for example by food overflow, leave the
burner cap in warm water and unclog the
holes using a non-metallic brush.
- Clean the greasy parts with soapy water
or a non-abrasive detergent (do not use a
10
•
) by