Qilive Q.5147 Manual Del Usuario página 16

Notes:
EN
• Ensure the robot vacuum cleaner, mobile phone or tablet and the router are close to
each other before starting the APP connection.
• Confirm the home router Wi-Fi signal type because a 2.4 GHz is required to add a
device.
• Wrong password is the main reason why pairing fails. Please check your password
and try again.
• To ensure successful pairing, it is recommended you enable the following access,
such as location, Wi-Fi, Bluetooth etc.
• Please complete the pairing within three minutes after the device is reset.
10. To connect the robot vacuum cleaner to the Wi-Fi network, switch it on by pressing
and holding the ON/OFF power button
in green colour. After that, press quickly the ON/OFF power button
consecutively. The Wi-Fi network icon
green colour. Add the device on you mobile phone. Tap "+" in the upper right corner
to add a smart device.
Note: The robot vacuum cleaner can be connected in the application installed on the
mobile phone or tablet in the two different methods from the top side of the APP:
- If you choose "Auto Scan", the "QILIVE SMART" application will automatically scan
and find the robot vacuum cleaner.
- If you choose "Add Manually", select "Small Home Appliances" and then choose
"Robot Vacuum (Wi-Fi)" from the list.
11. To add the device manually: Go to the "Small Home Appliance" bookmark and
search for "Robot Vacuum (Wi-Fi)".
Note: DO NOT SELECT OTHER DEVICES LIKE "ROOT VACUUM (BLE+WI-FI)",
"ROBOT VACUUM (BLE)", "ROBOT VACUUM (IPC) OR OTHER OPTIONS.
12. Select 2.4 GHz Wi-Fi network and enter the password.
13. Reset the device first. Power on the device and confirm that the Wi-Fi indicator
blinking rapidly. Tap
Note: Please complete the network distribution within 3 minutes after resetting the
device.
14. Adding device. Ensure that the device is powered on and the Wi-Fi signal is good.
15. After the robot vacuum cleaner is added successfully, you can start using the
application and control the robot vacuum cleaner remotely.
Note: If you wish to change the connection of the robot, from the existing Wi-Fi network
to a new Wi-Fi network, complete the following steps:
- Turn on the robot. Press quickly the ON/OFF power button
The Wi-Fi network icon
- Then, connect the device to the new wireless network.
4.6.2 SELECTING THE CLEANING MODES
Different cleaning modes can be selected from the application depending on your
preferences.
• The standard cleaning mode - auto cleaning, which is the most frequently used for
daily cleaning, can be started by selecting the "Auto cleaning" program.
• The "Room cleaning" mode is used to clean a single room.
• The edge cleaning mode is suitable for cleaning corners and along the walls and can
be started by selecting the "Edge cleaning" program.
• The "Spot cleaning" the robot will intensely clean a specific area, around the selected
starting point.
Note: Refer to the 4.8 CLEANING MODES paragraph for further information on cleaning
modes.
"Confirm the indicator is blinking rapidly."
on the robot starts blinking constantly in green colour.
16
. The ON/OFF light indicator illuminate
on the robot starts blinking constantly in
twice
is
twice consecutively.